RDMFC
Would you like to react to this message? Create an account in a few clicks or log in to continue.
RDMFC

Rhyl and District Model Flying Club

GET READY FOR THE NEW SEASON
THE GATE MUST BE KEPT CLOSED AT ALL TIMES
Log in

I forgot my password

RDMFC Social Media
RDMFC Facebook Page
Latest topics
» Am I ready for an edf jet?
3D Printing Empty2024-07-30, 08:27 by Daniel Gillespie

» Need help on how to just directly power my Detrum RXC6 6CH 2.4Ghz Receiver?
3D Printing Empty2024-07-17, 09:55 by Daniel Gillespie

» 2019 Llanfair TH Village Fete
3D Printing Empty2019-07-12, 18:53 by Rich

» Police crash
3D Printing Empty2019-04-14, 15:36 by Roy

» Bit of indoors
3D Printing Empty2019-04-13, 16:49 by Roy

Saturday 7/7/18

2018-07-07, 21:07 by Gary M Jones

I was at the field today between 14:00 & 15:00 all on my own , good flying too. There is a dead sheep along the fence line towards the gate from the pits, I saw the farmer so reported this to her. I hope no one had plans for a BBQ Smile .

Farmer …

Comments: 1


3D Printing

2 posters

RDMFC :: General Discussion

Go down

3D Printing Empty 3D Printing

Post by Andyedmead 2018-04-26, 22:17

Could anybody print me a small part?
Would pay in beer tokens.

Thanks

Andy

Andyedmead

Posts : 67
RDMFC Bonus points : 107
Join date : 2017-04-17

Back to top Go down

3D Printing Empty Re: 3D Printing

Post by Andy Sayle 2018-04-29, 22:04

Aye, no problem. What's the part you need?

Andy
Andy Sayle
Andy Sayle
Club Chairman

Posts : 4738
RDMFC Bonus points : -487569788
Join date : 2008-11-16
Location : Abergele, North Wales

Back to top Go down

3D Printing Empty Re: 3D Printing

Post by Andyedmead 2018-04-30, 10:02

Hi Andy, that would be great, the links are below. It's a motor mount and a nose cone for My radjet. Not desperate at all just thought they'd be good mods to have.


Andy


https://www.thingiverse.com/thing:2354684
https://www.thingiverse.com/thing:2453893

Andyedmead

Posts : 67
RDMFC Bonus points : 107
Join date : 2017-04-17

Back to top Go down

3D Printing Empty Re: 3D Printing

Post by Andy Sayle 2018-05-01, 20:44

They shouldn't be a problem, I'll get them printing for you at the weekend. The motor mount may work, but you will need to watch the motor temps. Anything above about 65degC and the plastic will soften.....
Andy Sayle
Andy Sayle
Club Chairman

Posts : 4738
RDMFC Bonus points : -487569788
Join date : 2008-11-16
Location : Abergele, North Wales

Back to top Go down

3D Printing Empty Re: 3D Printing

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

RDMFC :: General Discussion

 
Permissions in this forum:
You cannot reply to topics in this forum